From Main St, The Colony
Plumber Frisco, TX
Plumber in Frisco, about 7 miles from our Main St office in The Colony: water heaters first, then drains, leaks and fixtures, priced before work starts.
- Price first, every job
- Your yes before any work
- Old tanks and fixtures hauled off

Services
Plumbing jobs in Frisco
Water heaters first, then drains, leaks and fixtures.
Local notes
Inside Frisco homes
Frisco's houses are young. Census figures put the median year built at 2009, and 81.5 percent of the city's housing dates from 2000 onward. The 2010s were the big decade, with more than 32,000 units, and over 5,000 more have gone up from 2020 on. Fewer than two homes in a hundred predate 1980. So the plumbing is mostly the plastic of its era: PVC drains under the slab, PEX or CPVC supply lines, copper in some of the earlier houses. Cast iron and galvanized steel are rare. The work here is less about failing pipe and more about original equipment reaching its age. A tank heater set in 2009 is seventeen years old now, and fill valves, faucet cartridges and pressure valves wear on a similar clock. Owners live in about 66% of occupied homes; in the rest, the property owner may need to approve a repair before it starts.
The water comes from the city, which buys it treated from the North Texas Municipal Water District's Wylie Water Treatment Plant. NTMWD draws on Lavon Lake, Lake Texoma and several other sources, and the Texas Commission on Environmental Quality gives Frisco's system a Superior rating. Quality is not the problem; minerals are. The 2025 report lists total hardness of 96 to 200 ppm and calls the water moderately hard, roughly 6 to 12 grains per gallon. That leaves white spots on glass and lime scale on aerators, showerheads and the floor of a heater tank. Pressure is the other thing to know. Every new home built after 2001 had to have a pressure reducing valve, so most of the city has one. It usually sits near the meter, in a garage wall behind an access cover, or in a plastic box in the front bed beside the cleanouts, sometimes under the mulch. The code ceiling for house pressure is 80 psi, and a valve that creeps above it shows up as banging pipes, dripping relief valves and toilets that will not stop filling.
Permits run through Building Inspections at City Hall, 6101 Frisco Square Blvd. Applications go in online through the Plans and Permits portal, and inspections are booked in eTRAKiT. The city names water heater replacement, PRV replacement and every backflow assembly as permit work, while a minor part swap, such as a new heating element in an electric heater, needs none. From March 1, 2026, Frisco works from the 2024 International Plumbing Code with local amendments. On a sewer backup, the city inspects its own line before anything else and lets you know when the blockage is on your side; the house cleanouts, usually two white pipes out front, should stay visible. Gas comes from Atmos Energy or CoServ, depending on the street. And the city spans two counties, Collin to the east and Denton to the west.
- County
- Collin County (east) and Denton County (west)
- Water supply
- The City of Frisco, with NTMWD water
Nearby: Little Elm, Prosper
ZIP codes in Frisco
- 75033
- 75034
- 75035
- 75036
Questions
Asked in Frisco
Is every Frisco mailing address inside the city?
No. Census figures put only about 57 percent of ZIP 75036 in Frisco; the rest lies in The Colony, Hackberry, Little Elm or no city at all. Small edges of 75033 and 75035 fall outside the limits too. For most repairs that changes nothing. For permit work, such as a new water heater, the permit is issued by whichever city the address truly falls in.
Where is the main water shutoff in a Frisco house?
In most newer homes, look in the garage. The city says older houses tend to have it outside in a flowerbed. Find it and try it before a pipe ever breaks, so you are not hunting for it with water on the floor. If a line bursts and the valve will not close, the city's cold weather page lists a Public Works number to call.
What should I have handy when I call from Frisco?
The address, what is going wrong and where in the house. For a water heater, add gas or electric, the size in gallons and where it sits. For a drain, mention anything already poured down it: chemical openers change how a plumber can work on the line.
The heater is up in the attic. Does that matter?
No, though it changes the access more than the work. An attic heater should stand in a drain pan with its own drain line and have a shutoff valve within reach. Those are looked at too, and a new heater goes up the same way the old tank comes down.
Nearby
Other cities near The Colony
Trouble in Frisco? Price first.
Describe the problem and where it is in the house. You learn what is wrong, and the price of putting it right, before a wrench comes out.
