Daily 8 AM–8 PMOffice on Main St, The Colony

Lonestar Plumber in The Colony

Faucet Repair The Colony, TX

Faucet repair in The Colony should start with a screwdriver, not a sales pitch. We open the faucet, find the cartridge, washer or seal that wore out and replace that piece first. A new faucet comes up only when the body itself is finished.

  • Priced before the work
  • Started on your go-ahead
  • Tested, then cleaned up
Chrome pull-down kitchen faucet running water into a stainless steel sink set in a white countertop

How faucet repair works

Faucets control water in one of four ways: a rubber washer pressed on a brass seat, a cartridge, a pair of ceramic discs, or a ball with springs and seals. Where the water escapes points to the part. A spout drip is the valve. A leak at the handle or base is an O-ring.

Matching matters. Cartridges are often specific to one maker and model, so the old one comes out first and the new one is matched to it. Hard water shortens the life of every type.

Signs a faucet needs repair

  • A spout that drips after the handle is closed
  • Water pooling at the handle or the base
  • A handle that grinds, sticks or needs force
  • Weak flow at one faucet only
  • Water in the cabinet, or a sprayer hose that drips

Step by step

The job, in order

  1. Trace the leak

    Spout, handle, base or cabinet. Each points to a different part, so we watch it run before anything is loosened.

  2. Explain and price

    You hear which part has worn, what the repair costs and where a new faucet would make more sense.

  3. Rebuild

    Water off at the stops, handle off, the worn piece matched and replaced, the seals coated with silicone grease.

  4. Run and check

    Hot and cold run full, the handle turns the right way, and a dry towel under the sink proves the connections hold.

Local notes

Faucet Repair in The Colony

Water in The Colony is a blend. The city pumps from five wells of its own, four in the Trinity Sands aquifer and one in the Paluxy, and buys treated surface water from Dallas Water Utilities. Its 2025 water quality report puts hardness as high as 132 ppm, with 915 ppm of dissolved solids and a pH of 8.5 to 8.7. Mineral-heavy, slightly alkaline water leaves scale on seats, cartridges and aerators, which is often why a faucet here sticks or drips before its parts are truly worn.

Questions

Faucet Repair, answered

Is a slow drip worth repairing?

Yes. A steady drip wastes more water over a year than most people guess, and on the hot side it wastes heated water too. A worn part only gets worse.

Why does only the hot side drip?

Heat wears rubber faster. Washers soften and O-rings harden. Replacing the worn part on that side, or the cartridge on a single-handle faucet, usually ends it.

When is a new faucet the better buy?

Once the body cracks, the finish corrodes all the way through, or parts go out of production. Then faucet installation is the next step, and it can be a faucet you buy yourself.

How to book faucet repair in The Colony

Call (469) 940-4415 and tell us which faucet it is, which side drips and whether water reaches the cabinet. Look for a maker's name on the faucet or handle. If the leak will not stop, close the two valves under the sink.

Nearby

Faucet Repair near The Colony

Served from the office on Main St in The Colony.

Talk it through. Then decide.

First the cause, then the cost, then your decision.

Call now