Daily 8 AM–8 PMOffice on Main St, The Colony

Lonestar Plumber in The Colony

Toilet Installation The Colony, TX

Toilet installation in The Colony starts at the floor, not the showroom. Before the new bowl goes down, the flange under the old one is cleaned and checked. When the job is done, the old toilet leaves with us instead of waiting at your curb.

  • Priced before the work
  • Started on your go-ahead
  • Tested, then cleaned up

How toilet installation works

Three measurements decide which toilets fit. The rough-in, from the finished wall to the center of the floor bolts, is 12 inches in most homes and sometimes 10 or 14. Bowl length matters where an elongated bowl would crowd the door. Chair-height bowls sit a couple of inches above standard ones.

After that, the install is about the parts nobody sees. A cracked or sunken flange should be repaired, not hidden under a stacked wax ring. A shutoff valve that will not close is best replaced while the toilet is off.

When a new toilet is the better call

  • Cracked china anywhere, hairline fractures included
  • Clogs with ordinary use from an early low-flow model
  • A date stamped inside the tank from before 1994
  • Tank parts nobody makes anymore
  • A remodel, or a bowl too low for someone who needs it higher

Step by step

The job, in order

  1. Measure and price

    Rough-in, bowl length, door swing and the shutoff. One price for the job, flange repair included if it is needed.

  2. Pull the old toilet

    Tank drained, bowl lifted, and the drain plugged against sewer gas while the flange is cleaned and checked.

  3. Set the new one

    A fresh seal and bolts, the bowl leveled on a solid floor, the tank mounted and a new supply line connected.

  4. Flush and clear out

    Flushed several times, with the base and valve checked dry and the fill level set. The old toilet and the packaging go with us.

Local notes

Toilet Installation in The Colony

The Colony's permit sheet is specific about toilets: one replaced in the same spot needs no permit. Moving one is different, since the city requires permits for plumbing alterations, and on a slab, moving the drain means cutting concrete. About a fifth of the city's homes went up before 1980, nearly all in the 1970s, when Fox & Jacobs started building the city. A toilet in one of those houses that has never been replaced is worth pulling for the water savings alone.

Questions

Toilet Installation, answered

What changes the price of a toilet installation?

What sits under and behind the old one. A sound flange and a working shutoff keep it simple. A broken flange, a seized valve or a soft floor adds work. Wall-hung toilets need a carrier inside the wall.

Should the base be caulked?

Yes, at the front and sides, to keep mop water out and the bowl steady. Leave a short gap at the back, so a failed seal shows on the floor instead of soaking into it.

How much water does a new toilet save?

Toilets built before 1994 often use 3.5 gallons or more per flush. Current models use 1.6 at most, and many are rated at 1.28.

How to book toilet installation in The Colony

Call (469) 940-4415 with the rough-in measurement and the toilet you have in mind. Clear the floor around the old one and empty the shelf above the tank. On the day, we close that toilet's supply stop before anything comes apart.

Nearby

Toilet Installation near The Colony

Served from the office on Main St in The Colony.

Talk it through. Then decide.

First the cause, then the cost, then your decision.

Call now