Daily 8 AM–8 PMOffice on Main St, The Colony

Lonestar Plumber in The Colony

Faucet Installation The Colony, TX

Faucet installation in The Colony often means a faucet you already picked out, and that suits us: we fit the one you bought. What decides the job is the sink beneath it, so the holes, the valves and the room under the counter get checked first.

  • Priced before the work
  • Started on your go-ahead
  • Tested, then cleaned up
Chrome pull-down kitchen faucet running water into a stainless steel sink set in a white countertop

How faucet installation works

Count the holes before you shop. A single-hole faucet can cover three with a deck plate, but a three-hole faucet will not fit one. Bathroom faucets come as centerset, with handles four inches apart, or widespread, usually eight. A tall pull-down spout needs room to swing under a window.

Under the sink, the job is connections. New supply lines go on with the new faucet. An old shutoff valve that seizes or weeps when touched is best replaced now, and the lines are flushed before the aerator goes on.

Good reasons for a new faucet

  • A cracked body or a finish flaking away
  • Repairs that keep coming back
  • Parts no longer made for your model
  • A new sink, countertop or vanity
  • A wish for a pull-down sprayer or a lever that is easier on the hands

Step by step

The job, in order

  1. Check the fit

    Holes, spread, deck thickness, the shutoffs and the room below. Anything extra is priced before work starts.

  2. Remove the old faucet

    Water off, lines off, the old faucet pulled, corroded nuts and all, and the deck cleaned bare.

  3. Mount and connect

    The faucet is set on its gasket or putty, tightened from below and connected on new supply lines.

  4. Flush and test

    Lines flushed, aerator fitted, both sides run full, cabinet checked dry. The old faucet and the box go with us.

Local notes

Faucet Installation in The Colony

The Colony's service line inventory lists no lead lines: all of the more than 14,000 on record are non-lead. That covers the pipe from the street to the house, not the copper, solder and fixtures inside it. Roughly one home in five here dates from the 1970s, before lead solder was banned for drinking water in 1986, and an original faucet in one of them may hold more lead than a new one is allowed. Faucets sold for drinking water today have to meet the federal lead-free standard.

Questions

Faucet Installation, answered

Can you install a faucet I bought online?

Yes. Check the box first: some faucets ship without supply lines or a deck plate, and the hole count has to match your sink. Keep the instructions for any model-specific parts.

Does a bathroom faucet come with a drain?

Most come with a pop-up drain. It is worth swapping at the same time, since an old one often starts leaking once it is disturbed.

Why do some faucet installs take longer?

Access and corrosion. A faucet on an open vanity comes off easily. One under a deep sink, behind a disposal, with seized nuts, does not. Touchless faucets add a control box.

How to book faucet installation in The Colony

Call (469) 940-4415 with the sink type, the number of holes and whether the faucet is already bought. Empty the cabinet under the sink so the valves are easy to reach, and keep every part of the new faucet in its box.

Nearby

Faucet Installation near The Colony

Served from the office on Main St in The Colony.

Talk it through. Then decide.

First the cause, then the cost, then your decision.

Call now