Lonestar Plumber in The Colony
Garbage Disposal Installation The Colony, TX
Garbage disposal installation in The Colony is quoted as a single price covering the full hookup, set before the old unit comes out. Swapping a worn unit is the simple job. A first install needs power in the sink cabinet, typically an outlet on a wall switch, so that is checked first.
- Priced before the work
- Started on your go-ahead
- Tested, then cleaned up

How garbage disposal installation works
Size the unit to the kitchen. Light use needs less motor than nightly cooking. Bigger motors handle tougher waste and jam less, but they are taller, and height matters under a sink. Continuous-feed units run off a switch; batch-feed units start only with the lid in place.
The drain sets the limit. The disposal outlet has to sit above the point where the drain enters the wall, or water stands in the pipe. Where the dishwasher discharges into the unit, the knockout disc in its inlet must be removed.
When a new disposal makes sense
- Water dripping from the base of the unit itself
- A motor that hums or trips after every reset
- Jams every week, or grinding that never finishes
- Rust on the housing or a cracked sink flange
- A new sink, or a kitchen that never had a disposal
Step by step
The job, in order
Measure and quote
Clearance, drain height, power and the dishwasher connection, all covered by one price you approve first.
Take out the old unit
Power off, lines disconnected, and the old unit and its flange taken out of the sink.
Mount and connect
A new flange is sealed in, the unit locks onto its ring, and the drain and dishwasher hose go on with the knockout removed.
Test under load
The unit grinds under running water, a dishwasher cycle drains through the new inlet, and the flange, elbow and hose are checked dry. The old disposal goes with us.
Local notes
Garbage Disposal Installation in The Colony
The city's list of permit jobs never mentions disposals. It exempts a sink reinstalled where it was, but it does name p-trap replacement as permit work, and that line matters here. When a new unit sits higher or lower than the old one, the trap under the sink may have to be replaced to line up with the drain. The price you get says whether yours will, before anything is ordered or removed.
Questions
Garbage Disposal Installation, answered
The dishwasher won't drain since the new disposal went in. Why?
Almost always the knockout plug. New disposals ship with the dishwasher inlet sealed by a plastic disc, which has to be punched out and fished from the chamber before the hose goes on.
Do I need an outlet under the sink?
Most disposals plug into an outlet there that a wall switch controls; some are wired in directly. If the kitchen has neither, that wiring has to be in place first, and you will know before any work starts.
What size disposal should I get?
For light use, 1/2 horsepower is enough. Heavy cooking or a big household calls for 3/4 or 1 horsepower. Check the unit's height against the space under your sink first.
How to book garbage disposal installation in The Colony
Call (469) 940-4415 and say if there is a disposal now and if the dishwasher empties into it. If you have a model in mind, have its name and height ready. Clear out the sink base before the visit.
Nearby
Garbage Disposal Installation near The Colony
Served from the office on Main St in The Colony.
