Daily 8 AM–8 PMFound. Fixed. Tested.

Dallas–Fort Worth

Gas Line Repair & Installation in Dallas–Fort Worth

Gas piping has to hold pressure, full stop. We test the system, repair what fails, run new lines sized for the load and test again.

  • A price before any work starts
  • Your approval before we begin
  • Tested before we go
Gas tank water heater in a garage alcove with copper lines, an expansion tank, a vent pipe and a drain pan

What you should know

Safety comes first. A gas smell means get out of the house. Do not flip switches, start a car in the garage or go looking for the source. Once you are outside, phone the gas utility's emergency line or 911. For most of the Metroplex the utility is Atmos Energy. The utility makes the situation safe, usually by shutting off the meter.

What comes next is plumbing work. Everything downstream of the meter is the homeowner's piping. Putting the entire system under test pressure reveals whether there is one leak or several. We repair or replace the failed pipe, then test again. For new appliances we add up the load and size the line so the range, the furnace and the water heater can all run at once.

When a gas line needs a plumber

  • Your gas utility has shut off the meter or tagged an appliance
  • You are adding a range, dryer, tankless water heater, generator or pool heater
  • An appliance connector is old, kinked or made of uncoated brass
  • Yellow flexible gas tubing (CSST) in the attic has no bonding wire attached
  • Grass or plants are dying in a line above a buried gas pipe

Process

The job, step by step

  1. Make it safe

    Nothing is loosened until the supply is off and the section is isolated.

  2. Pressure-test

    The piping is pressurized with air to a set figure, and the gauge needle has to hold. If it falls, we hunt down every leak.

  3. Repair or install

    Failed pipe is replaced. New lines are sized for the total load, supported, and fitted with a shut-off at each appliance.

  4. Test and inspect

    A final pressure test is held for the city inspector. Once it passes, the utility can restore service, and the appliances are relit and checked.

Local context

The North Texas factor

In North Texas the path back to gas service runs through city hall. Once a utility locks a meter for a leak, it generally keeps it locked until the customer's piping is fixed, proven tight under test and signed off by a city inspector. That makes the repair, the permit and the test a single job. Older homes here often have threaded black steel pipe, and buried steel lines to pool heaters or detached garages can corrode from the outside. Many homes built from the 1990s on have yellow CSST, which needs a bonding wire to the home's electrical ground. Without that bond, CSST can be punctured by the energy from a nearby lightning strike, and this is thunderstorm country.

Questions

Gas Lines questions, answered

What is the right order of steps when I smell gas?

First, get everyone out, and touch no switches, appliances or phones on the way. Second, once you are well away from the building, call 911 or the gas utility's emergency line. Third, stay outside until the gas utility clears the house. The pipe repair comes after that.

Why is my gas still off after the leak was found?

A locked meter stays locked until the utility has evidence that the house piping no longer leaks. Three things have to happen: the leak is repaired, the piping holds pressure on a test, and the city inspector, where one is required, signs off. With the inspection on file, the utility restores service. Fixing the pipe and running the test is the plumber's side of it.

I am adding a big gas appliance. Is my existing line enough?

It has to be calculated, not assumed. Tankless water heaters, standby generators and pool heaters each pull far more gas than a range or a tank water heater. We total the demand of everything on the system, compare it with the meter and the pipe sizes, and tell you whether the current line will do, needs upsizing or should be a new run.