Daily 8 AM–8 PMOffice on Main St, The Colony

Lonestar Plumber in The Colony

Shower Installation The Colony, TX

Shower installation in The Colony, as we do it, is the plumbing: valve, supply lines, drain, arm and head. The new lines are tested under pressure before any wall closes, and the tile, pan and glass are left to the trades that build them.

  • Priced before the work
  • Started on your go-ahead
  • Tested, then cleaned up

How shower installation works

Start with the valve, since it stays in the wall for decades. A pressure-balancing valve holds the temperature when water use changes elsewhere. A thermostatic valve holds it more precisely and can feed several outlets, with separate volume control. More outlets need more water, so pipe size and the water heater are checked first.

The valve's depth is set to the finished wall, tile and backer included, or the trim will not seal. On a slab, the drain sits in concrete, so keeping the old drain spot is the simpler build. Moving it means cutting the floor.

When the plumbing needs a new install

  • A tub coming out and a walk-in shower going in
  • A remodel with the walls already open
  • Separate hot and cold handles on a valve with no anti-scald balancing
  • Plans for a handheld, a rain head or a second outlet
  • A leaking valve body that a cartridge cannot fix

Step by step

The job, in order

  1. Plan the layout

    Valve type, outlets, heights, drain position and the order of work with your tile setter, all priced before anything starts.

  2. Rough in

    The valve is set at the right depth, supply lines run to it and the arm, and the drain set where the pan needs it.

  3. Test before closing

    The new lines hold test pressure and the drain is checked before any wall or floor is covered.

  4. Trim out

    After the tile, the trim, arm, head and spout go on, the temperature limit is set and every outlet is run.

Local notes

Shower Installation in The Colony

In The Colony this is permit work. The city's permit sheet names the removal and replacement of showers and mixing valves, and a tub-to-shower conversion that changes the plumbing needs a permit as well. Permits go through Building Inspections at City Hall, 6053 Main St., and inspections can be booked in the city's eTRAKiT portal. One caution: nearly half the land in ZIP 75056 lies outside the city, mostly in Lewisville or no city at all, so the mailing address alone does not settle which permit office applies.

Questions

Shower Installation, answered

Do you do the tile too?

No. We do the plumbing in and behind the wall. Tile, the waterproof pan, glass and drywall belong to a tile setter or remodeler. The plumbing is roughed in before their work and trimmed out after it.

Can a new valve go in without redoing the wall?

Sometimes. Some valve makers offer replacement valves with oversized trim plates that cover the old opening. Otherwise the valve is reached from the back of the wall when that side is drywall.

Pressure-balancing or thermostatic?

Pressure-balancing suits most single-head showers. Thermostatic suits several outlets, separate temperature and volume control, or the steadiest temperature. It costs more and needs more depth in the wall.

How to book shower installation in The Colony

Call (469) 940-4415 with the plan: tub-to-shower conversion, remodel or valve swap, and who is doing the tile. Know which outlets you want and roughly where. If the walls are already open, say so, since what is exposed shapes the plan.

Nearby

Shower Installation near The Colony

Served from the office on Main St in The Colony.

Talk it through. Then decide.

First the cause, then the cost, then your decision.

Call now