Daily 8 AM–8 PMOffice on Main St, The Colony

Lonestar Plumber in The Colony

Shower Repair The Colony, TX

Shower repair in The Colony begins with where the water is actually going. You get a plain account of the source, whether valve, pipe, drain or grout, before any tile or drywall is touched. Most drips and temperature swings are fixed from the front, through the handle.

  • Priced before the work
  • Started on your go-ahead
  • Tested, then cleaned up
Clear water pooling along a white baseboard on a light gray tile floor

How shower repair works

Behind the handle is a valve body with a cartridge or stems inside. Most newer cartridges balance hot and cold pressure, so the temperature holds when a toilet flushes. When scale sticks that balancing spool, the shower swings hot or cold. When the seals wear, the head drips.

Leaks behind the wall follow a pattern. Constant wetness is the supply side. Wetness only with the shower on sits between valve and head. Wetness as the floor drains is the drain. Wetness after a spray on the tile is grout or caulk, which is tile work.

Signs your shower needs a repair

  • A showerhead or tub spout still dripping once the handle is off
  • Scalding or cold bursts when someone flushes
  • Never hot enough, even turned all the way
  • Weak spray, or a tub spout that runs in shower mode
  • A stained ceiling below or a wet baseboard beside it

Step by step

The job, in order

  1. Isolate the source

    Supply, valve, head, drain and tile are tested one at a time, so the cause is found rather than guessed.

  2. Explain and price

    You hear what failed, why and how it will be reached. The trim comes first; opening a wall is the last resort.

  3. Repair

    A new cartridge or stem washers, a reset limit stop, a new diverter spout or the failed fitting behind the wall.

  4. Test hot and cold

    Full hot, full cold and a flush test for balance. Then the tub and floor are wiped down.

Local notes

Shower Repair in The Colony

Two local facts shape shower repair in The Colony. The city lists mixing-valve replacement as permit work, so a new cartridge is a repair but a new valve needs a plumbing permit. And with water as hard as 132 ppm in the city's 2025 report, scale builds in cartridges and showerhead nozzles until the spray thins and the balance sticks. In the city's 1970s housing, an original valve may predate pressure balancing entirely.

Questions

Shower Repair, answered

Why won't my shower get hot enough?

If the rest of the house has hot water, check the valve. Most single-handle valves have a limit stop that caps how far the handle turns toward hot. It may be set low or knocked loose. A worn cartridge is the other usual cause.

Can a leaking shower be fixed without tearing out tile?

Usually. Cartridges, stems and diverters come out through the trim, and pipe behind the valve can often be reached through drywall on the other side. If tile must come off, retiling is someone else's work.

What if the shower pan is leaking?

A failed pan means the floor comes up and is rebuilt by a tile setter. Our part is the drain, reset or replaced while the floor is open.

How to book shower repair in The Colony

Call (469) 940-4415 and describe what the shower does and where water shows up. If the trim plate carries a maker's name, note it. Showers rarely have a shutoff of their own, so if water keeps running hard, close the main valve.

Nearby

Shower Repair near The Colony

Served from the office on Main St in The Colony.

Talk it through. Then decide.

First the cause, then the cost, then your decision.

Call now