Lonestar Plumber in The Colony
Faucet Installation Corinth, TX
Faucet installation in Corinth is handled from our Main St office in The Colony, roughly 19 miles away, and a faucet you picked out yourself is welcome. Hole count, valves and cabinet space are checked before anything is priced, and the old faucet and the packaging leave with us.

Corinth homes and faucet installation
The typical Corinth home was built around 1997, and the faucets that came with it, where they survive, are close to thirty years old. A replacement in a house of this age usually means new supply lines too, since the originals are often the same vintage. The shutoff valves under the sink get a look while the faucet is off; valves that sat open for decades can seize or weep once turned. Count the holes in the sink deck before shopping as well: a three-hole sink takes a single-hole faucet only with a deck plate over the spares, and the plate has to suit the faucet's finish.
New construction is the other end of town. Walton Ridge's single-family homes and the townhomes at The Brookman in Downtown Corinth were finished within the last year, and in a home that new a faucet change is an upgrade rather than a repair: a pull-down kitchen spout, a touchless faucet, or a vanity set that matches new hardware. The supply lines and valves are fresh, so the job is mostly fit and finish. A pull-down sprayer needs room below the sink for its hose weight to travel, and a disposal or filter cartridge in the way changes where things can hang.
The water a new faucet will carry comes from Lewisville Lake, bought by the city from Upper Trinity and treated with chloramine. The lines are flushed before the aerator goes on, so loose grit from old valves does not lodge in the new one. The city's conservation rebates cover toilets, irrigation equipment and sensors rather than faucets, so a WaterSense faucet saves water without a city check attached. Once the faucet is on, both sides run full, the handle is checked for direction, and a dry towel under the sink shows whether every connection holds.
Corinth at a glance
- County
- Denton County
- Typical home
- Median year built 1997
- Water supply
- City of Corinth, buying treated water from Upper Trinity (UTRWD)
- Permit office
- Building Services, City Hall, 3300 Corinth Pkwy., (940) 498-3207
- Permit portal
- Civic Access portal (replaced eTrakit in March 2025)
- From our office
- About 19 miles from our Main St office in The Colony, mostly by I-35E
Good reasons for a new faucet
- A cracked body or a finish flaking away
- Repairs that keep coming back
- Parts no longer made for your model
- A new sink, countertop or vanity
- A wish for a pull-down sprayer or a lever that is easier on the hands
Questions from Corinth
Do I need a permit to replace a faucet in Corinth?
The city publishes no list that covers faucets, and its permits page says only that major construction needs one, with Building Services available to check. Swapping a faucet on an existing sink, with the supply and drain left where they are, is not construction. Moving a sink or adding a new line is a different matter, worth a call to the city first.
We just bought a 1990s house. Which faucets should we change first?
Start with any that drip, stick or leak into the cabinet, then the kitchen, which gets the most use. Look under each sink at the same time: supply lines that are kinked or corroded, and shutoffs that will not turn, are worth replacing while the faucet is off anyway. Each faucet is priced separately, so you can stage the work.
Can you install a faucet I bought online?
Yes. Check the box first: some faucets ship without supply lines or a deck plate, and the hole count has to match your sink. Keep the instructions for any model-specific parts.
Booking in Corinth
Call (469) 940-4415 with the sink type, the number of holes and whether the faucet is already bought. Empty the cabinet under the sink so the valves are easy to reach, and keep every part of the new faucet in its box.
