Daily 8 AM–8 PMOffice on Main St, The Colony

Lonestar Plumber in The Colony

Faucet Installation Flower Mound, TX

Faucet installation in Flower Mound fits the faucet you picked, wherever you bought it. First the plumber checks the hole count in the sink, the stop valves' condition and how much room the cabinet below allows, and anything extra is priced up front. The old faucet leaves with the plumber afterward.

Chrome pull-down kitchen faucet running water into a stainless steel sink set in a white countertop

Flower Mound homes and faucet installation

Lead is a fair question when a faucet goes in, and the street side has a clean answer here. Every one of the 23,904 service lines feeding homes in town has been inspected, and none came back as lead or as unknown. Any faucet sold today for kitchen or bath use has to meet federal lead-free limits, and a house from 1997, the town's median year, was plumbed after lead solder was banned in 1986. An old faucet that came with the house is the piece that predates today's standard.

Adding a fixture, or putting a sink somewhere new, is a bigger job than a swap. It changes supply and drain lines, falls under the 2024 IRC that took effect on October 1, 2025, and is the kind of question Building Inspections answers before the work begins. Keeping the faucet where the old one stood avoids all of that, which is why most installs here are straight replacements. A one-piece vanity top or an undermount kitchen sink sets the hole count, so it is checked against the new faucet before the old one is loosened.

Once the faucet is mounted, the supply lines are flushed with the aerator left off, a habit that pays with lake water purchased from UTRWD as well as Dallas Water Utilities. Work on any water main can stir up sediment, and an aerator catches it. The Town publishes no hardness figure for its water, so the aerator is also the easiest place to watch for mineral buildup in the years after the install.

Flower Mound at a glance

County
Denton County (a small part in Tarrant County)
Typical home
Median year built 1997
Water supply
Town of Flower Mound, buying treated water from UTRWD and Dallas
Permit office
Building Inspections, Town Hall, 2121 Cross Timbers Rd., 75028
From our office
About 13 miles from our Main St office in The Colony, mostly by SH 121

Good reasons for a new faucet

  • A cracked body or a finish flaking away
  • Repairs that keep coming back
  • Parts no longer made for your model
  • A new sink, countertop or vanity
  • A wish for a pull-down sprayer or a lever that is easier on the hands

Questions from Flower Mound

Is a permit required to swap a faucet in town?

The Town's guidelines say plumbing generally needs a permit and point to heater jobs and to water and sewer line repairs, yet a faucet swap at the same sink is not singled out. Moving the sink or adding a fixture is different, and Building Inspections settles that question before work starts.

Is it worth changing the stop valves at the same time?

If they came with a house built in the 1990s, often yes. Valves that age tend to seize or weep at the stem once they are turned, and the faucet swap is the one moment they are easy to reach. The plumber tests them first and prices a replacement only if they fail to close cleanly.

Can you install a faucet I bought online?

Yes. Check the box first: some faucets ship without supply lines or a deck plate, and the hole count has to match your sink. Keep the instructions for any model-specific parts.

Booking in Flower Mound

Call (469) 940-4415 with the sink type, the number of holes and whether the faucet is already bought. Empty the cabinet under the sink so the valves are easy to reach, and keep every part of the new faucet in its box.

Start with the symptom.

Call now